Kenwood Kr 710 Manual -

Use TAPE A for your primary deck. Connect the deck's outputs to the "PLAY" jacks and inputs to the "REC" jacks.

Ensure the AC voltage switch (110–120V or 220–240V) matches your local power supply before plugging in. 3. Technical Specifications Specification Power Output 28 watts per channel into 8 Ωcap omega Frequency Response 7Hz to 200kHz Total Harmonic Distortion Signal-to-Noise Ratio 78dB (Phono), 104dB (Line) Dimensions 458 x 123 x 298 mm (approx. 18" x 4.8" x 11.7") 4. Basic Troubleshooting Kenwood Kr 710 Manual

Set to "ON" to reduce high-frequency noise like tape hiss or record scratches. Use TAPE A for your primary deck

Connect your turntable’s left/right phono plugs here. Use the GND terminal for the turntable's ground wire to prevent humming. Antenna Setup: Connect an indoor 300 Ωcap omega Basic Troubleshooting Set to "ON" to reduce high-frequency

FM antenna to the FM terminals. For best results, spread the antenna arms horizontally against a wall.

Boosts bass at low volume levels. Turn off for normal or high-volume listening.

Use the A/B switches to activate speakers connected to the rear terminals. Setting the switch to the center (marked with a prime symbol) activates both sets simultaneously. Audio Filters: